4.重机373型立式扣夹的装置与应用方法(国外英语资料).doc

4.重机373型立式扣夹的安装与使用方法 Installation and using method of 4. heavy machine 373 type vertical buckle clip Vertical type 373 heavy machine buttoning machine clip by clip lift rod, clip fixed block, left and right clamping rod, a spring, a spring rod, elastic fixing block, clamping rod and other components combined, is a kind of auxiliary tool by hand on the buckle, buckle, only for this special kind of vertical buckle specializes in the use of. To remove the original set of parallel down clip (two eyes, four eyes), the vertical clip set installation, plug clip fixing pin and the connecting head, plug the circlip, the whole clip will not come out in the process of using it. The number of column head tail, there will be four eye or eyes split rod length distance, gently pushed to the left vertex, marked with two position, hanging clip clip mounted on the lifting rod, a pressure spring and spring rod. According to the needs of eyes do not have to adjust the number of needles, because with small number of stitches, therefore, the whole clip into two halves, each half can stitch a button. The adjustment method is the left cover open, can see the stop lever and the gear position, there is a protruding pin in the parking wheel, the pin is pulled outward, while advancing the second hole below, this button pin number is only half of the original number of nail, when not to push back. The hand barge open clip rod, a vertical side buckle, buttons on the right side of the line must be in the tail of the nail clip in a fixed block, loosen the clamp rod, the clamping rod against the button head (button surface), look at how the top of the elastic, can tighten loose clamping rod spring, tight reverse, then the spring fixing screw, loaded buckle is not easy to shake, pop prevail. The first clip middle gap of the fixed block (concave), alignment below the nail plate hole and a middle plate hole position, such as no alignment, should adjust the clip two fixing screws on the fixed block, l