ETC解码器操作流程(国外英语资料).doc

ETC解码器操作流程 Set the dimmer brightness directly with CEM [Dimmer] [8] [At] [Rack:1, 1st, System, OK, UD:1] [Dimmer:1, NOT, SET*] [Dim:8, NOT, SET*] [Dim:8@NOT, SET*] Here, Dimmer Doubled mode [AT] [A / B] [Dim:1A, NOT, SET*, NOT, SET*, Dim:1B] [Dim:1A@NOT, SET*] [Dim:1B@, NOT, SET*] Set dimmer brightness 1 press [Dimmer] 2 press [1] [Thru] [6] [At] choose dimmer 1 to 6, Dim:1 6 @ 25 3 [=] or [in] down to increase or decrease the dimmer brightness, also available digital key input (0-100) 4 press [Enter] Clear dimmer brightness 1 press [Dimmer] 2 press [1] [Thru] [6] [At] choose dimmer 1 to 6 3 press [Clear] [Enter] to complete, dimmer light into NOT SET, Dim:1 6 @ NOT SET Obtain the dimmer, dimmer cabinet and system information in CEM [About] [Rack:1, 1stUD#:1, System, OK] [Abour, 1-Dimmer, 2-Rack, 3-System] [1] [About Dimmer], 12*D15AF, [About Dimmer 12* 1 Rack:1 Slot:6 About Dimmer 12* Rec], [Load:1000W], [About], Dimmer 12* Act Load:1000W Dimmer 12* Level About [0], About [Dimmer 12* OK] [2], [About Rack 1* 60Hz V1:120 2:120 3:120 About Rack 1* Start], [Addr:1], [About Rack 1* DMX PortA:OK About Rack 1* DMX], [PortB:Disabled], [About Rack 1* Amb Temp:70F Rack 1* TYpe:SR48AF], [About] [3] [About, System, panic:INACTIVE], [About, System, Backup,, INACTIVE], Theater, [About, System, Name, Players, and I) The on menu allows you to see the dimmer, dimmer cabinet and system information, but cant change anything in the menu Dimmer: can see each dimmer type, address, location, Fiao, load, photometric and error information. Dimmer: you can see the call voltage and frequency of the dimmer cabinet, the starting address, the status of the DMX interface A, the status of the DMX interface B, the temperature and the type of dimmer cabinet. System: check whether emergency or standby fields in the system are activated and the actual system name. 1 press [1] [About] to enter the sub menu A single dimmer number (UD#) is displayed on the first line of the 2 display screen 3 press []