Router OS 的详细的设置方法(国外英语资料).doc

Router OS 的详细的设置方法 Detailed settings for Router OS [blades and wounds are published in 2007-5-12 17:57:00] The routeos version that can now be used is only 2.7.14, because only this has a counting machine, and the new version of 2.8 has not been updated because of changes in the algorithm. The release version of Routeos with CD-ROM and floppy disk version (9), but under VMware or VPC, these discs are not normally read, so I was in the installation process will not only use text, drawings. First, make a disk of the downloaded CD image or install floppy disk, start the boot sequence in CMOS and start from CD or floppy disk. In the first step, the installer will let you select the components you need to install. When you choose, press I to start the installation and then press y to complete the installation. After the completion of the installation, the first entry will require the input registration code, and then use the count machine, in the numbers above the column to enter the machine code, you can get the registration code (note the input case). The default account entered for the first time is: admin, the password is empty. The basic settings: (I follow telnet and the routing winbox) 1, set the network card (this step needs to be executed in this machine, not set IP, telnet and other tools are not available) Enter the set settings in enable interface card, the card name (the first line of the input can be either ether1 or ether2 and other representatives of first and two card); the input card IP in IP address (this can be a network card binding multiple IP); in the netmask line input subnet mask. A powerful part of routeos is that it can use multiple network cards, and you can freely specify these network cards as different segments (either external or intranet) After all set card, you can use telnet on this route, or you can use IP to access the http:// routing routing, routing in this comes with a web with a tool called winbox, you can use this tool to access