48伏电瓶车充电器原理(国外英语资料).docVIP

48伏电瓶车充电器原理 Charger principle of 48 volt battery car.Txt At present, the most widely used and also the earliest single ended drive for direct drive MOS FET switches is MC3842. MC3842 in the stable output voltage at the same time, also has the control function of the load current, which is often called the current mode switching power charger for drive, undoubtedly this function has a unique advantage, only a few external components can achieve constant voltage output, and can control the charging current. Especially, MC3842 can directly drive the characteristics of MOS FET tubes, which can greatly improve the reliability of charger. Because MC3842 is widely used, this article only introduces its characteristics. MC3842 as the excitation switching power supply of double row 8 foot single ended output driver circuit, the internal function includes a reference voltage regulator, error amplifier, pulse width comparator, latch, oscillator, pulse width modulator (PWM), pulse output driver etc.. MC3842 similar products, including interchangeable UC3842, IR3842N, SG3842, CM3842 (domestic), LM3842 and so on. The internal block diagram of MC3842 is shown in figure 1. Its features are as follows: Single ended PWM pulse output, output drive current of 200mA, peak current up to 1A. The starting voltage is greater than 16V and the starting current is only 1mA. After entering the working state, the working voltage is between 10 and 34V, and the load current is 15mA. Beyond the normal operating voltage, the switching power supply enters the undervoltage or overvoltage protection state. At this point, the integrated circuit has no drive pulse output. The 5V/50mA reference voltage source is set and the 2:1 voltage is used as the sampling reference voltage. The output drive pulse can either drive the bipolar transistor or drive the MOS fet. If a bipolar transistor is to be driven, the RC cutoff acceleration circuit should be applied to the base of the switch tube, while the oscillato