丝印中网版的绷网技术(国外英语资料).doc

丝印中网版的绷网技术 Screen printing in the net version of the wire mesh technology I. the tension of tension net: In the mesh screen, wire diameter and mesh textile pattern and the selection of materials directly affect the mesh size of the tension, the tension and the network, is measured according to the tension of these parameters on the screen, measuring the tension, tension is detected from the network box side should 10 centimeters, or measured the tension is not accurate. For SEFEN PET 1000, the maximum values of each mesh can be found in the following table. The maximum tension value is the specific intensity of the screen to display the table, namely all kinds of mesh, the maximum tensile force of different wire diameter can withstand and rebound value, if more than the given in the table of tension mesh will lose elasticity, become plastic deformation, which should be paid attention to in the tension and the network. Tension unit: Newton / cm (N/CM), available Newton tensiometer measurement. The tensiometer can measure the warp and weft tension. The warp tension of the screen is the tension on the direction of the winding of the whole reel, that is, the tension on the edge of the edge; the tension of the screen is the tension in the direction of the width of the screen. The tension can be seen in the table, the same kind of material for different wire diameter, different mesh size of the screen, the tension is different, which is the same mesh size of the screen, the tension is different, which is the same mesh size of the screen, wire diameter, the tension is different, because tensile is with the wire diameter is proportional. For example, A is 2 times the radius of B wire, and the tensile strength of A wire is 4 times of that of B wire. In the table the tension value of high strength of side length of about 1 meters below the frame effectively, when the edge length of 2 meters of the screen frame, then tension values should be reduced to 15%-20%, if the network