主机配件(国外英语资料).docVIP

主机配件 ASR Automatic server recovery can monitor server performance and restore the server to its normal state after a critical fault occurs DHCP DHCP is a software that automatically assigns IP addresses to the user side of a TCP/IP network that is called a dynamic IP address (IP). This software is usually performed on routers and other network devices. By pre-set, your GateLock router is set to use DHCP, so you dont have to manually assign a permanent IP address to each device on the network. It is recommended that you do not change this setting so that your personal computer can be identified as a DHCP server. ECC memory Full name Error Checkingand Correcting. It is also in the original data to achieve the putting position. For example, 8 bits of data require 1 bits for the Parity test, and 5 bits for the ECC, and the extra 5 bits are used to reconstruct the wrong data. When the number of bits in the data doubles, the Parity doubles, while ECC simply adds one bit, and when the data is 64 bits, the ECC is the same number as the Parity (both 8). Where Parity can only detect errors, ECC can correct most of the errors. If the work is normal, you will not find that your data is out of order, and only after memory error correction, the computers operation instructions can continue to perform. Of course, the performance of the system has been significantly reduced in error correction, but this error correction is important for servers and other applications, and ECC memory costs are much more expensive than regular memory. IA schema server Usually will use Intel processor server called IA (Intel Architec-ture) server, because the server architecture uses an open system, and the implementation of the industry standard technology and obtained a large number of hardware and software suppliers at home and abroad, based on mass production, with its high price performance ratio in the world in particular, has been widely applied in china. IDE IDE (Integrated Device Electronics)