农用运输车聚散器的罕见弊病(国外英语资料).doc

农用运输车离合器的常见故障 1, clutch separation is not complete, the power can not be cut off in time (1) symptom of malfunction. When the clutch pedal lever, gear gear difficult, mutual impact sound transmission; gear not loose the clutch pedal, agricultural vehicles can walk slowly; when parking, the clutch pedal, still feel the parking difficulty, not easy to remove the gear lever. (2) the possible cause of the failure. Improper adjustment of the clutch pedal free travel, too large, when the pedal, the clutch cant be completely separated; friction flake, adjustment or 3 separate lever is not consistent with the height, not in the same plane, resulting in partial wear of unilateral separation and friction; new friction plate replacement is too thick, the adjustment of free travel after the total travel restrictions, separating stroke friction plate is too small; the friction plate assembly of the internal spline and the first axis of each rust, or the first shaft spline wear serious, pits, pedal, friction plate assembly can slide smoothly along the first axis spline, the dynamic friction plate is not completely separated; positive and negative assembly installed wrong, because the friction plate assembly and inner splined sleeve length asymmetry, if one end towards a flywheel long installation, will cause the separation is not complete; the clutch shaft on the flywheel shaft rolling The rust is killed or stuck, so that the flywheel and clutch shaft form a whole, so that the clutch does not work or separation is not clear. 2, clutch slipping, power transmission can not be normal (1) symptom of malfunction. Agricultural vehicles slow at the beginning; in motion, when the engine speed increases when the speed is not increased; agricultural vehicles in the gas under the condition of constant load start, the engine speed has no obvious change; agricultural vehicles with load or when the load increases will stop; friction caused by strong friction. (2) the possible cause of the fai