冲压填空(国外英语资料).doc

冲压填空 Punching blank.Txt makes people miss death. It is the supreme state of murder. Even forensic doctors can not identify the cause of death...... Fill in the blanks The main parts of the 1. blanking die are punch, concave die and concave convex die. 2. according to the stamping process, the stamping die can be divided into single process die, compound die and progressive die. 3. the basic parts of die set for stamping die include upper and lower die seat, guide post and guide sleeve. 4., the basic process of stamping processing can be divided into two types of separation and molding. The fit between the 5. guide posts and the guide sleeve in the assembly of the die base is interference fit 6. cold stamping process at room temperature, in the press, the use of the mold to the material pressure, so that it produces separation or plastic deformation, so as to obtain the required parts of a pressure processing method. 7., to make the cold stamping die normal and smooth work, we must request the die pressure center and die handle axis line requirements coincide (or offset little). 8. the closing degree of the ordinary crank press refers to the distance between the bottom surface and the plane of the worktable. The closing height of the die refers to the distance between the upper part of the die seat on the die and the lower plane of the lower die seat when the die is in a closed state. 9. when choosing a press, the closing height of the die must be between the maximum closing height of the press and the minimum closing height. 10. press with overload protection function is the rubbing press. The adjustable punch is an eccentric punch. 1. blanking process consists of two processes, blanking and punching, respectively. 2., the blanking deformation includes three stages of deformation process, namely, elastic deformation stage, plastic deformation stage, shear cracking separation stage. 3. the section of ordinary blanking has four obvious areas, namely, slump band, brigh