力学性能钢材加工图册(国外英语资料).docVIP

力学性能钢材加工图册 General 1: this atlas is compiled according to the national standards and the ship classification regulations of each classification society. If the requirements of the national standards and the ship classification regulations of each classification society have been modified, the atlas shall be modified simultaneously Two: this atlas is only for our common material test Three: sample processing process, should be strictly in accordance with the sample processing drawings and size processing Four: in order to guarantee the quality of the test, the sample must be processed strictly according to the requirements of the album. In order to ensure the quality of sample processing, the following requirements are made for the relevant working procedures 1 sawing machine: according to the atlas of the largest part of the size, leaving 5mm processing allowance 2 planer: for impact specimens, leave the 0.3mm-0.5mm allowance according to the maximum part size specified in the atlas 3: the last cutting grinder, lathe cutting should be controlled within 0.01mm 4 sample burr must be clear, sharp edge should be inverted garden, arc radius is not greater than 2mm Five: the symbols, names and units used in this album are shown in the following table: L total length unit LC specimens parallel length mm L0 specimen original gauge distance mm L1 specimen centerline distance, specimen edge length mm LS specimen holding part length mm LW length of weld mm D round sample parallel part diameter or round tube specimen original internal mm D round sample holding part diameter or round tube specimen original outer diameter mm DW bend test elbow diameter mm A the original thickness of an arc or an arc specimen or pipe wall mm A1 sample notch at the bottom of the original thickness mm B rectangle, arc sample parallel part width mm B rectangle, arc specimen holding part width mm R sample chamfer Radius mm R take the lead sample from the head to the parallel part of the Transition Ar