压缩空气管道安装标准(国外英语资料).docVIP

压缩空气管道安装标准 This article is contributed by laural12 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Standard for installation of compressed air piping and acceptance standards for engineering installation of pneumatic equipment Refer to GB 5038-2006 as a general rule Pipes and pipes, pipes and equipment are not to be joined by strong counterparts. Compression rust, welding slag, burrs, oil and water contamination on the surface of the carbon steel pipe should be air before painting, before the test, weld shall be painted carbon steel pipe compressed air pipe welding butt weld should adopt argon arc welding or argon arc welding backing and filling. Compressed air pipe butt weld appearance quality of carbon steel is not allowed to have cracks, porosity, slag, dissolve splash and incomplete penetration: undercut depth is less than 0.5mm, and the total length of the weld seam on both sides of the less than 10% of the full length of the weld, and less than or equal to 1+0.1b (b weld width), and no more than 3mm. Pipe making, pipe cutting and pipe beveling shall be done by mechanical processing. The end face of the notch shall be smooth and the end face should be perpendicular to the axis of the pipe. The deviation shall be 1% of the pipe diameter and shall not be greater than 2.0mm. Pipe welding groove type and size shall comply with the welding operation instruction, and the iron groove, burr and so on shall be removed after the machining of the groove. Pipe bending should meet the following requirements: 1, bending cold bending should be adopted, the minimum bending radius should not be less than The outer diameter of the pipe is 3 times; the radius of bending shall not be less than 1 times of the outer diameter of the pipe when the stamping elbow is used. 2. The maximum outside diameter and minimum outer diameter after bending shall not exceed 8% of the pipe diamete