土木试卷11(国外英语资料).doc

土木试卷11 First, noun interpretation (2 * 3 points) 1. hydrophilic 2. thermosetting resins Two, fill in the blanks (5 x 3 points) Water resistance, fire resistance ____ ____ 1. gypsum products. Compared with 2. Portland cement and Portland cement lime volcano, good impermeability ____ cement. 3. grades of Q235-A? B steel, steel ____ performance compared to Q235-D. 4. concrete admixtures containing chloride ions in concrete with no ____. 5. when the asphalt resin (asphalt mastic) component content is higher, the degree of asphalt ____. Three, non judgmental questions (5 * 3 points) 1. the fineness modulus is bigger, which means sand is thicker. The weldability of 2. medium carbon steel is better than that of low carbon steel. 3. waterproof coating is liquid before curing, especially for irregular roof, joints and other complex surface, can form a seamless waterproof membrane. 4. the technical property of petroleum asphalt is worse than that of coal tar, but it is seldom used in building engineering, but its corrosion resistance is better. It is often used as anticorrosion layer and underground waterproof layer. 5. wood is most likely to contract along the chord when it is dry. Four, multiple-choice questions (5 * 3 points) 1. a, B two bar diameter is the same, the bending angle of the bending test of the same, a bending center diameter smaller, two steel cold bending properties ____. A and armour are better B, the same C and B are better 2. high alumina cement 3 days strength ____ the same strength of Portland cement. A, below B equals C, higher than The thermal conductivity of 3. materials increased with temperature ____. A, unchanged B, increase C, decrease The atmospheric stability of 4. asphalt to asphalt test in evaporation loss percentage before and after evaporation and evaporation penetration ratio rating, ____. The smaller the percentage of evaporation loss in A, the greater the degree of evaporation penetration, indicating slower aging of asphalt The smaller