抽凝机改为背压机存在的严峻平安题目(国外英语资料).doc

抽凝机改为背压机存在的重大安全问题Important safety problems existing in the condensate machine instead of back pressure machineThermoelectric master --- originalityDue to the rapid rise in coal prices, the heat and power plant suddenly found that the pumping machine run at a loss, and smart people immediately go ahead, quickly turn the condensate machine back pressure machine. I think it is necessary to explain what is the condenser and what is the back pressure machine Because people can not engage in power clearly, condensate pumping machine is steam into the turbine blades, impulse power, the general pressure level in the cylinder impeller, a steam hole, removing a part over the power of steam, this is a bit like the rest of the reheater steam, continue to work. After entering the condenser cooling; and there is no back compressor condenser, that is to say, the steam into the turbine, work done after the low pressure steam supply to heat users. The back pressure machine and the pumping unit, the thermal efficiency is much higher than the pumping unit, therefore, back pressure machine in such a high coal prices, but also survive.After the condensate machine is changed into a back pressure machine, there is no doubt about the economy. But I want to talk about the problems existing in the security and how to avoid them.It is a good thing that the operation of the condensing machine can not only supply heat, but also supply power stably. That is, the pumping system regulates both thermal and electrical loads. The back press is different, it can not adjust the electrical load, and its electric load can only be changed passively according to the load of heating. At the same time, the back pressure machine can only regulate the heating pressure, and the heating load is also passively controlled by heating users. So, this is a problem, you know, thermal power plant power through the transformer in the power grid and the power plants own use up from the power grid, some factory is connect