施工工序(国外英语资料).doc

施工工序 Two, the construction requirements (a) material requirements 1, the construction unit of the construction materials of cement, clay brick, clay brick, clay brick, high hole aerated concrete block masonry, must carry out inspection and approval procedures, supervision company checks, prohibited unqualified materials into the construction site. 2, aerated concrete block is cement gel strength to 28 days as the standard of design strength reinforced bulk, and before the age of 28 days did not reach the bulk itself, shrink rapidly. In order to avoid shrinkage cracks and ensure the quality of masonry, the aerated concrete block must reach 28 days old. (two) masonry requirements 1. The foundation walls in contact with the soil must be made of clay solid bricks. No clay big hole brick or clay porous brick shall be strictly prohibited. 2, in accordance with the requirements of the mandatory provisions of the Ministry of construction, the bathroom wall must be cast height greater than 200mm, more than C20 concrete label on the ridge. 3, other parts of infilled masonry wall, the bottom should be building height of more than 200mm of clay solid brick or precast concrete block. 4, fill masonry wall, clay hollow brick brick hole should ensure that the level of porous clay brick masonry, brick masonry should ensure the vertical hole; clay brick, clay brick, clay brick masonry in the big hole must use the day before the water soaked, aerated concrete block suitable amount of water in the surface of masonry masonry. 5, infilled masonry mortar must be strictly in accordance with the weight ratio of measurement preparation, with the mix with the use, the normal temperature finished within 4 hours, if the temperature is above 30 degrees must be finished within 3 hours, prohibited the use of overnight mortar. Infilled masonry should be double thread, staggered a brick, no seams, aerated concrete block lap length should be greater than the length of the 1/3 block, the clay hollow