木工机械(国外英语资料).docVIP

木工机械 Safety operation rules for woodworking machines (1) woodworking machinery operators must be proficient in the construction, performance, operation and maintenance methods of various machines, and be responsible for the use of special personnel and special personnel. (two) the operation of woodworking machinery, should wear working clothes, tie cuffs, women must wear a hat, braided into the cap; not wearing gloves, scarves and other operations. (three) before the machine starts to work, the test must be carried out, and the parts can be operated normally before they can start work. (four) the protection cover and protective board shall be provided for the shafts, chains, pulleys, belts and other moving parts of the woodworking machinery. (five) if there are abnormal conditions or other faults in the operation of the machine, the power supply shall be cut off immediately, and the parking service shall be checked and repaired. (six) the replacement of knives, saws, must cut off the total power. Woodworking machinery requirements for workplace 1. any process that uses toxic, irritating, and flammable materials shall be in a separate plant or arranged in a specific section of the building and equipped with personal protective equipment and fire protection equipment. 2. workshop transport logs, sawn timber, waste channel should be set up and eliminate Chuantangfeng facilities such as corridors, lobby, curtain, curtain and prevent the spread of fire facilities such as automatic fire doors, fire smoke baffle, water curtain etc.. 3. in the workshop need to safely reach the top of the equipment work should be installed with protective railings and staircases overpass. Skid proof floor shall be installed on the ground and overpass. 4. there is no equipment or wires on the pedestrian lane that is commonly used. Its width is not less than 1m. Transfer 5. below ground to cover with Qi with cover or Shan lattice on the protection board. The surface of metal plate should be a