机械设计复习题及答案(国外英语资料).doc

机械设计复习题及答案 First, the multiple-choice question 1. for the calculation of tooth surface contact fatigue strength of involute cylindrical gear transmission, the contact stress at (C) is used as the calculation stress. (P165) A addendum B root C node 2. which of the following shafts is a mandrel? (A) P235 The front axle of the A bicycle, the C axle in the middle axle of the B bicycle, the spindle of the D lathe 3. which of the following is not characteristic of splines? (D) P251 A carrying capacity is big, B is good for neutral and good for steering C cost is high, D can bear axial component force 4. normally, the failure of plain plain keys is (D) P250 A pitting failure, B shear failure, C contact failure, D extrusion failure In a 5. hinged four bar mechanism, if the sum of the length of the shortest rod and the longest rod is greater than the sum of the other two rod lengths, the mechanism (B) is used. P23 A must have a crank, B must have no cranks Does C have a crank, and it depends on which part the frame is The main use of the 6. keys is (C). P246 The A provides a relative relative movement between the shaft and the hub, B, which achieves axial relative slip between the shaft and the hub C enables the shaft and wheel hub to be circumferentially fixed and transmits torque D, so that the shaft and the hub are axially fixed 7., the basic components of rolling bearings are 1), inner ring, 2), outer ring, 3), rolling body, 4) cage, which is the indispensable part? (C) (A, 1) B 2) C 3) D 4) 8., when the band length increases, the power delivered by a single V band (A). P99 A increases B, constant C decreases, D does not necessarily change 9., a crank rocker mechanism will be transformed into a double rocker mechanism, which can be converted by a rack (C). P23 A the crank of the original mechanism acts as the frame, and the connecting rod of the original mechanism of the B is used as the frame The rocker of the C original mechanism serves as the frame 10., the speed rati