柴油叉车行走有力的弊病启事与消除及防备办法(国外英语资料).docVIP

柴油叉车行走无力的故障原因与排除及预防措施 Cause, troubleshooting and preventive measures of diesel forklift trucks failure to walk 1. The pressure of the hanging gear is less than one M. The watch means the bell is unstable, and all the gears are unable to walk. Normal gear pressure is 1. 1 to 1. The 4 pressure, such as below this standard, the gear clutch due to poor oil pressure, friction plate bonding bad, resulting in slipping, forklift performance as walking weakness. The reasons may be as follows: there is not enough oil in the gearbox; the suction air in the gear pump is working; the filter of the transmission system is blocked; the oil suction pipe is aging; the inner layer is peeling. The gear pump of this kind of transmission has two thick and thin filters before and after the gear. If the dirt is blocked, the oil absorption is insufficient, and the oil can not be supplied. Two: one is out of gear or gear, the rest of the stalls are normal. The root cause is the failure of the shift clutch. The failure reasons, the clutch friction plate burning temperature deformation, the clutch piston return spring failure, damage to the O ring transmission shaft and the input shaft of the poly four vinyl rotating seal ring damage or deposit on the shaft end, the oil pan gasket bad pressure oil leakage. Three: cold car stalls can work normally, when all gear driving slowly, sometimes even can not walk. The reasons may be: hydraulic transmission oil by improper selection of properties of the oil viscosity temperature that oil viscosity decreases with the increased temperature, viscosity characteristics of different types of oil are not the same, such as oil, improper selection, will directly affect the normal use of the machine, the operating gear pump, rotary sealing ring for hydraulic components the long-term work and wear, the main gap has exceeded the limit. Due to the large viscosity of the oil in the cold car, the leakage is less in the system flow, and the system pressure loss is sma