注塑机(国外英语资料).docVIP

注塑机 One Fault and maintenance of 2009-02-26 08:57 injection molding machine hydraulic system fault diagnosis of hydraulic system of injection molding machine, is often limited by the field conditions and requirements as soon as possible after a failure, so as not to affect the construction schedule. This paper introduces several fault diagnosis methods of injection molding machine injection molding machine hydraulic system, which are for reference. 1. visual inspection For some relatively simple fault, by seeing, Shoumo, hearing and smell of parts inspection. For example, in the maintenance of injection molding machine hydraulic system, found such as rupture, leakage, loosening and deformation failure to imagine through visual inspection, so in a timely manner to repair or replacement parts; hold the tubing (especially the hose), when there is pressure on the oil flow out of date will be the feeling of vibration, without oil flow or pressure is too low when there is no such phenomenon. In addition, the hand can also judge with mechanical transmission components of hydraulic components is good for lubrication, hand feel element shell temperature changes, if the shell element overheating, poor lubrication; ear can determine the mechanical parts damage caused by the fault point and the extent of the damage, such as hydraulic pump, relief valve, open air the card will be issued a fault element impact sound such as water or water hammer and other abnormal noise; some parts due to overheating, poor lubrication and cavitation caused by sniffing the odor, can determine the fault point. 2. transposition diagnostics In the maintenance of the lack of diagnostic instruments or checked parts are more accurate, not open, it is recommended to use this method. First, the suspected fault components were removed, replaced with new parts or other machines on the normal work, the same type of components for testing, to see if the failure can be excluded, you can make a diagnosis. Diagn