流化床锅炉原理(国外英语资料).docVIP

流化床锅炉原理 What are the principles of a circulating fluidized bed boiler? How do we operate, adjust and start a shutdown? What should we pay attention to? In short, that is: Coal (Shi Huishi) was sent into the combustion chamber, the material is a blown furnace in the upper part of the combustion, large particles (not full combustion) through its own gravity along the inner wall of the hearth in the lower part of the furnace, so the cycle, called internal circulation. The small particles are sucked and entrained by the flue gas into the cyclone separator, and are dropped into the back feeder by centrifugal force and gravity, and are sent into the furnace through the feed back wind and the loose air. Constitutes an external loop. The dust collector is sucked into the dust collector and is discharged into the flue after dust removal Run this problem, you first read it, you will know: (25----34) 25. What are the factors affecting the thermal efficiency of CFB boilers? The quality of the boiler load and one or two times the ratio of oxygen and air exhaust temperature and fan outlet temperature and carbon content of fly ash and carbon content in slag and the temperature of slag to water temperature. 26 、 what effect does the air flow rate have on the combustion? The operating air flow is usually expressed by excess air factor. In a certain range, increasing the excess air coefficient can improve combustion efficiency, combustion zone because oxygen concentration increases the combustion efficiency and combustion degree, but the excess air coefficient is more than 1.15 continue to increase the combustion efficiency almost has no effect on the excess air coefficient is very high; make the bed temperature decrease, CO concentration increased, decreased, combustion efficiency the total electricity consumption of the fan increases, so the oxygen content at the outlet is generally maintained 3% - 4%. 27, what is the adjustment principle of air flow in CFB boiler operation? The pr