电动推杆道理(国外英语资料).doc

电动推杆原理 Sort: 1, according to the form of screw: trapezoidal screw type (Kang Sophia KA10-70), ball screw, ball screw rod type planetary roller screw, etc.. 2, according to motor types: DC motor type (12/24/36V), AC motor (220/380V), stepper motor, servo motor, etc.. Main structure: The electric push rod is composed of a driving motor, a reduction gear, a screw rod, a nut, a guide sleeve, a push rod, a sliding seat, a spring, an outer shell, a turbine, a inching control switch, etc.. The electric push rod is a new type of electric actuator. The electric push rod is a new type of linear actuator composed of motor, push rod and control device. It can realize remote control and centralized control. Electric push rod in a certain range of travel within the round-trip movement, general electric putter standard stroke in 100150200250300350400mm, special trip can also be designed according to different application requirements. The electric push rod electric push rod can be designed according to the different application of different thrust load, the maximum thrust is 6000N, no-load running speed of 4mm~35mm/s, the electric push rod with 24V/12V permanent magnet DC motor as the power source, the motors rotary motion into linear reciprocating motion. Push a set of connecting rod mechanisms to complete the switching of dampers, valves, gates, baffles, etc.. Using the electric push rod as an actuating mechanism can not only reduce the air supply device and auxiliary equipment required by the pneumatic actuating mechanism, but also reduce the weight of the actuating mechanism. Pneumatic actuator in the entire process of control need to have a certain air pressure, although you can use a small amount of amplifier, etc., but over time, the gas consumption is still huge. The actuator adopts electric push rod, you need to supply change control, opening, opening in time to achieve the required power can not, therefore, from the energy perspective, the electric push rod actuator act