电接点压力表电器道理图(国外英语资料).doc

电接点压力表电器原理图 Electrical contact pressure meter electrical diagram. Encountered some friends ask electrical contact pressure gauge how to control the starting and stopping of the motor, I searched the schematic diagram of it in Baidu. Found that the search chart almost all the same, temporarily can not read it, thank you for this bar, friends, cuidaifeng . With his help, I read the artwork and explained it and corrected it. Offer everybody now, the hope can give novice electrician to know a figure to bring convenient. Structure principle: The instrument is composed of measuring system, indicating device, magnetic assistant electric contact device, shell, adjusting device and junction box. When the measured pressure acts on the spring tube, its end produces a corresponding elastic deformation displacement, which is indicated by the indicating device on the dial when magnified by the drive mechanism. At the same time the pointer drives the movable contact of the electric contact device and setting contacts on the pointer (upper or lower) instantaneous contact, resulting in the control system to connect or disconnect the circuit, in order to achieve the purpose of automatic control and alarm. Electrical contact signal needle in electric contact device, some equipped with permanent magnet adjustable, can increase the contact force, speed up the contact action, so that the contact reliability, eliminating the arc, can effectively avoid the instrument because of environmental vibration or medium pressure pulsation caused by frequent contact off. Therefore, the instrument has the advantages of reliable operation, long service life and large power of the contact switch. Appliance principle: To control the compressor motor as an example: gas storage pressure reached the lower limit, automatically opened, reached the upper limit automatically stop. The control process is as follows: (or when the pressure reaches to the low and lower limit), electric contact pressure gauge mova