BROCADE交换机配置(一)(国外英语资料).docVIP

BROCADE交换机配置(一)(国外英语资料) BROCADE switch configuration (1) There are three ways to interact with a switch: A serial port Ethernet front-end ports Optical fiber mouth The default serial parameter is: 9600, N, 8, 1 The default IP access method is: IP address: 10.77.77.77 User name: admin Password: Time zone: Pacific time Switch name: switch You can use the ipAddrSet command to reset the switchs IP address. In the 2000 and 3000 series switches, only one Telnet process can be supported. Brocades switches can be managed using command lines and graphical interfaces. Representative CLI methods such as Telnet, HyperTerm and tip. For Fabric OS v4.1, SSH v2 can be used. If Brocade Secure Fabric OS is set up, the CLI interface must be Brocade Secure Telnet. Brocade API v2.1 provides users with a way to extend access to the switch; It is easy to integrate Brocade SAN Fabrics intelligence to existing management applications, or to rapidly develop special features of the user SAN. The toolkit is available through the Brocade Connect site. Brocade Fabric Manager v4.0 is a real-time management Brocade optical switches, and more than a good tool, it provides efficient configuration, monitoring, dynamic resource allocation management. Brocade Web Tool is a straightforward management Tool for managing small SAN networks. Run the Web Browser that supports JRE. Brocade provides SNMP based MIBs to read and configure public Settings on switches. A serial port management: N a serial connection cable DB9 (female - to - female) Use a super terminal or a UNIX terminal N Windows: Hyper Terminal N UNIX: tip U Microsoft Windows? environment Transmission rate: 9600bit/SEC Data bit: 8 Check bits: None Stop: 1 Flow control: None U UNIX? In the environment, enter the following command # tip/dev/ttyb-9600 U installation step Connect the two through a serial line Make sure the switch has been charged Set the IP address with the ipAddrSet command (note: the command is case sensitive, but all uppercase o