CASS成图注意事项LCD(国外英语资料).docVIP

CASS成图注意事项LCD(国外英语资料) 1, in drawing a picture, the scarp line and line of the slope, graphics to open the picture, after save scarp line and line of the slope became a all dont take candy and slope of the line, after the restart the current normal form shown in the figure, but reopened after inventory figure, linear again without candy and the slope of the line. The reason: this is just a display problem that doesnt affect print, and you want to display the AUTOCAD configuration as normal. Click the display option to show the accuracy - - - - round and... Set it up a little bit bigger. Or enter REGEN on the command line to display. 2, on a computer made of southern open thought figure is to another computer to open some gibberish, tip has a lot of * * undefined, then I copy the past, still cant display properly. The solution to this problem is to make a copy of C: SCASSCASWINs * SHX file to ACADs SUPPORT directory. If CASSs right screen menu shows a blank solution, the first option is to have a display option in the AUTOCAD option. Second: drag it in the middle of the screen and drag it in the lower right corner to see the content. The installation of cassis should be installed after the installation of AutoCAD 2000 and running once. 6, drawing house notes: Draw A multi-room hint: close C/partition G/A little bit of J/microconductor A/microconductor A/curve Q/line/line/line/point P / dot enter 51, return the car. Select multi-point concrete house and automatically read the code of the earth. Since the third popup many options, lie between function, for example, input J, input and system will calculate automatically make that point with the former point and the connection to the input point is right Angle. Closed type C, said: the wire function by user input current point to the next point of the left Angle (degrees) and the distance (m), after the input point will be calculated and the attachment. If you type in the Angle of the input, you can enter the Angle dir