cisco接口大全(国外英语资料).docVIP

cisco接口大全(国外英语资料) This article will provide a comprehensive introduction and analysis of the router network interface through an example. We were divided into three parts on the router network interface analysis of (a) the analytical of router network interface (2) the analytical daqo router network interface (3). (1) the interface and the active state The (2) hardware field provides you with the hardware type of the interface (3) the Internet address (4) MTU (5) BW (6) DLY (7) reliability (8) load (9) encapsulation (10) loopback (11) ARP type (12) ARP timeout (13) the final input and output (14) output interrupt (15) the last removal (16) queuing strategy (17) queue messages (18) 5-minute I/O speed (19) grouping and byte input No buffer (20) (21) the broadcast received (22) Runts (23) Giants (24) Throttles Example: Router # show interface e0/0 Ethernet0/0 is up, line protocol is down Hardware is AmdP2, address is 0009.4375.5 e20 (bia 0009.4375.5 e20) Internet address is 192.168.1.53/24 MTU 1500 bytes, BW 10,000 Kbit, the words, 1000 usec, Reliability 172/255, txload 3/255, rxload 39/255 Encapsulation ARPA, loopback not set Keepalive set (10 SEC) ARP type: ARPA, ARP Timeout, 04:00:00 Last input never, output 00:07, output hang never This is the Last clearing of the show interface Input queue: 0/75/0/0 (size/Max/flushes); The Total output Drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/Max) 5 minute input rate 0 bits/SEC, 0 SEC/SEC 5 minute output rate 0 bits/SEC, 0 SEC/SEC 0, input, 0 bytes, 0 no buffer Received 0, runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0, ignored Input is being detected with dribble condition 50 output, 3270 bytes, 0 underruns 50 the output errors, 0 collisions, 2 interface resets Babbles, zero late collision, zero deferred 50 lost carrier, 0 no carrier Zero output buffer failures. Zero output buffers swapped out (1) the interface and the active state In the above display, the content indicates that the hardware inte