光纤收发器指示灯含义(国外英语资料).doc

光纤收发器指示灯含义(国外英语资料) Fiber optic transceiver indicator meaning In the case of fibre-optic transceiver failure, the meaning of the optical transceiver indicator was never memorized. Fiber optic transceiver indicator meaning: Optical transceiver has six LED lights, they showed the working state of the transceiver, according to the LED, can judge the transceiver is working correctly and may have what problem, which can help to find fault. Their roles are as follows: PWR: lighting indicates that DC5V is working properly FX 100: light indicates that the optical fiber transmission rate is 100Mbps FX Link/Act: the light long indicates that the fibre links are connected correctly; The lights say that there is data in the optical fiber FDX: light indicates that the optical fiber transmits data in full duplex TX 100: light indicates double stranded wire transfer rate of 100Mbps; The lamp does not highlight the double stranded speed of 10Mbps TX Link/Act: the light is long to indicate the Link to the double stranded Link; The lamp indicates that there is data in the double stranded wire Here are some help to diagnose the breakdown of lights: A, such as a transceiver (FX) indicator lamp is not bright, please determine if the fiber link is interlinked? One end of a fiber optic jumper is a parallel connection; The other end is intersecting. B, such as A transceiver mouth (FX) indicator light, the light of b transceiver (FX) light is not bright, failure in A transceiver end: one possibility is that: A transceiver (TX) send light is bad, because b transceiver mouth (RX) receiving less than light signal; Another possibility is that A transmitter (TX) optical link is problematic (the cable or light jump line may be broken). The c, double stranded (TP) indicator lamp is not bright, please be sure that the double stranded wire line is wrong or the connection is wrong. Please check with the pass tester; (some of the transceivers, however, have to wait for the fiber link to be switched on.