场效应管,三极管,可控硅-(国外英语资料).doc

场效应管,三极管,可控硅-(国外英语资料) How do you identify the field effect tube, triode, thyristor Generally speaking, the type of resolution is first from the model: IRFxxxx. It is usually the field effect tube BT is usually a thyristor (and, of course, some of the other prefixes that start with other prefixes: such as 2nxxxxxxxx. (2).axxxxx. Mjex.tixxxx. It is usually a triode (but there are also fewer of them Part of the model is silicon controlled or field effect tube). In this way can classify about the part of the field effect tube and SCR is, of course, to determine the basic parameters of concrete according to the model parameter or resources Triode triode is determined by the judgment Triode tube type and the recognition of the pin is a basic electronics beginners, four mantra: three upside down, looking for the base; the p-n junction, tube type; along the arrow, large deflection; uncertainty, move your mouth. . One, three upside down, look for the base As you know, triode is a semiconductor device with two PN junction. According to the two PN junction, the three transistors can be divided into NPN and PNP types, which are their circuit symbols and equivalent circuits. Test the triode to use the ohm of the multimeter, and select R * 100 or R * 1k. Figure 2 draws the equivalent circuit of ohm block. As shown in the diagram, the red pen is connected to the negative electrode of the battery in the table, and the black marker is connected to the positive electrode of the battery in the table. Lets say we dont know whether the triode is NPN or PNP, and its not clear what the electrodes are. The first step in the test is to determine which is the base. At this time, we take two electrodes (e.g., the two electrodes are 1, 2), with a multimeter two pens and reverse its positive and reverse resistance measurement, whose hands the deflection Angle of observation; Then, two electrodes, two electrodes, two electrodes and two electrodes were taken to measure their positive and reverse