投影机维修常见问题解决方案(国外英语资料).docVIP

投影机维修常见问题解决方案(国外英语资料) The projectors repair common problem solutions Q: how does the maintenance service of the NEC projector operate? A: NEC has set up a projector maintenance service center in Beijing and provides all users with warranty CARDS (except water). Users fill in warranty card, together with the purchase documents copy fax or send to NEC projector maintenance center, after the registration after the warranty procedures can take effect. When the machine has a maintenance requirement, it can contact the maintenance center directly or through the dealer. Q: what about the color impurity in RGB mode? Answer: if auto adjust closes, open it; When auto adjust is turned on, turn off the image and adjust the image balance with positioning and clock. Q: the remote control doesnt work. What to do? A: new batteries; Be sure there are no obstacles between you and the projector; Located within 22 feet of the projector; Verify that the PJ key is red, in the projector mode, otherwise, press the PJ key. Q: what happens when the image is horizontal and vertical? Answer: use a menu or remote signal source key or the key on the chassis to select the type. Q: what if the image is not clear? A: focus. Rearrange the projector and adjust the Angle. Determine the distance between the projector and the screen. Q: what if the screen image is not a rectangle? Answer: reframe the position of the projector and the screen. Use the trapezoidal correction function. Q: what if there is no image? Answer: use the menu to select the source (video, s-video, RGB1, RGB2, or PC card reader). Confirm that the connection is correct; Use the menu to adjust brightness and contrast. Remove the lens cover; Reset and adjust the advanced menu image options application factory default mode. Q: what if you cant turn on? A: check the power cord interface, the switch on the projector and the remote control power. Make sure the bulb is properly installed; Check whether the projector is overheating or the u