施工工艺标中(国外英语资料).docVIP

施工工艺标中(国外英语资料) Standard lighting installation engineering standard 1 scope Applicable to indoor and exterior electrical lighting fixtures. It does not apply to special places such as mines, ships, operating rooms, etc Gas lighting fixtures installation engineering. 2 reference standard Construction quality acceptance specification (gb50303-2002) Building electric general atlas (92dq-6) The fourth branch of the construction process discipline (DBJ 01-26-96) 3 construction preparation Equipment and material requirements The models and specifications of the 3.1.1 lamps and lanterns must conform to the design requirements and national standards. All lamps and lanterns should have CCC certificate and product certificate. The shape of 3.1.2 lamps and lanterns should meet the following rules: 3.1.2.1 lighting fixtures and accessories are complete without mechanical damage, deformation, peeling of coating, breakage of lamp shade, and crooked lamp box. 3.1.2.2 except open lamps and lanterns, all kinds of light bulb capacity of various kinds of lamps and lanterns are used in 100W and the people with the porcelain lamp head; No damage or leakage of the insulated enclosure of 3.1.2.3. The lamp with the switch, the switch handle has no bare metal parts. The wire voltage level used for lighting lamps should not be lower than the ac 500V, and the minimum core section should meet the requirement of table 1. 3.1.4 the insulation resistance, internal wiring, etc. Of the complete set of lamps and lanterns are tested in random sampling. The quantity is controlled at about 10% of the lamps Insulation resistance value is not less than 10 M Ω, (2) the internal wiring to copper insulated wire, wire cut area of not less than 0.5 mm 2 Rubber or polyvinyl chloride The insulation layer of the insulated wire is not less than 0.6 mm. The test room shall issue a test report to confirm the compliance with this standard and relevant technology The standard rules are applied in construction. The new