混凝土浇筑方案 及注意事项(国外英语资料).docVIP

混凝土浇筑方案 及注意事项(国外英语资料) The concrete pump USES maintenance points Concrete pump truck has been used in the construction of concrete pouring, the advancement and the maintenance of the equipment technical complexity, determines the use, maintenance and management of it staff to put forward higher requirements. In order to ensure the concrete pump truck at work can meet the technical condition, reduce the maintenance cost, improve the use of reliability and life expectancy, must seriously implement the use of maintenance procedures. First, safety procedures In order to ensure the safety of the concrete pump operation and avoid causing personal or equipment accidents, the following safety procedures must be strictly observed. Venue selection. Avoid obstacles such as high pressure lines as far as possible. Check before homework. The power switch should be in the off position. The concrete displacement handle and the mixing device shall be in the middle position. Step 3. The concrete pump should be placed horizontally, the ground should be flat and firm, and the working process will not be sunken. The leg stabilizes the whole machine reliably and securely. Arm bracket operation. When the arms are stretched or repossessed by folded states, they must be carried out in the prescribed order. The rotary operation of the arm frame must be carried out after the arm frame is completely off the bracket. The arm frame shall not be used when the storm or wind is above 8 or above (wind speed 16 ~ 17m/s). Arm frame must not be used for lifting. Pump delivery. When the pump is started or stopped, contact the operator at the end hose. The curved radius of the end hose shall not be less than 1m and not bending; Before disassembling the pipe, the pump should be pump 2 ~ 3 times before removing the remaining pressure in the pipe. Check after homework. The arm frame should be fully recovered from the arm frame. The legs should also be fully recovered and inserted into the lock pin. The power