热喷涂铝技术在电缆桥架上的应用(国外英语资料).docVIP

热喷涂铝技术在电缆桥架上的应用(国外英语资料) The application of hot spray aluminum technology on the cable bridge Yin ling Urumqi petrochemical general plant equipment installation company, urumqi 830019 Keywords: hot spray aluminum cable bridge is enclosed 1 introduction Wu petrochemical corporation fertilizer plant new cable tray because of large granule urea unit is located in the urea prilling tower, under the environment such as NH3 and H2S, SO2, urea dust corrosive substances, these substances is exposed to the air for the cable tray can lead to different degree of corrosion. Fertilizer plant of the original cable tray has been adopting alkyd enamel anticorrosion and chlorosulfonated polyethylene coating anticorrosive methods, such as the effect not beautiful, only one year bridge appeared corrosion phenomena. In order to prolong the life span of the outer coating of the cable bridge, it is determined to use thermal spray aluminum technology to embalm the cable bridge of the large particle device. Corrosion analysis Large granule urea device cable tray from the sun, wind, rain and snow, frost and dew, and the function of temperature and humidity change by all the year round, including atmospheric oxygen and the moisture is the important factor of corrosion of cable tray, caused electrochemical corrosion. During normal driving, cable tray of NH3 and H2S, SO2 in the atmosphere, nitrogen oxides, and urea dust, etc., and its content was about 0.823 mg/m3 NH3 and SO2 0.025 mg/m3, nitrogen oxides, 0.04 mg/m3, and in the open parking or not under normal circumstances, the NH3 and H2S, SO2 concentration in the atmosphere will be higher, although these component content is less, but is cannot be ignored for the steel corrosion harm, the biggest effect of SO2. These gases dissolve in water to form acid rain and corrode metal facilities. The application of hot spray aluminum technology on the cable bridge In order to reduce the occurrence of corrosion, the service life of the cable bridge i