若何破解网通限制(国外英语资料).docVIP

如何破解网通限制(国外英语资料) How do you break the restrictions on Internet access by netcom (unicom) to scan the MACs IP, seal routers, and share the restrictions of 1,709 people How do you break the limitation of network connection scanning MAC IP, router, and sharing How to crack the firmware of two routers on the January 12 diary of the Internet connection scanning MAC IP, router, and anti-sharing. How to crack the netcom (China unicom) scan MAC IP sealing, sealing routers, sharing limit In the morning, I break out bleary, solemn and stirring, with a do or die, brush for two routers firmware. One is the tp-402m I used before, and one is the lei section 205 + that is being used. The latest firmware is found on the Internet, and it is hard to believe that both firmware are specially written for users in shandong province, which are used to guard against netcom. After I decompress, I start getting ready for the router to prepare for an upgrade. However, the input 192.168.1.1 is not an administrative interface. It took a long time, but it didnt work. Does the tp -402m die like that? Resume factory setting. Use a ball-point pen to resist the reset button, then add electricity, such as M1, M2, two lights at the same time, loosen the ball-point pen, all the lights router, and then to add power, input 192.168.1.1, can enter the management interface, restore the factory Settings success! Update the firmware immediately, restart automatically after 20 seconds, and prompt for success. The upgrade firmware takes less than 20 seconds, 20 seconds cant be blackouts, otherwise the router will die. The routers firmware hung up, it is difficult to repair, can only put the storage block the firmware of the EEPROM chip pry, hang interface matching and can write code on the single chip microcomputer, rewrite the firmware. Or, instead, use the router as a switch. There is no firmware, and the built-in exchange function can be used. By rewriting the firmware, my old router was able to escape the