第二种形式重力机原理验证实验装置(外国英语资料).docVIP

第二种形式重力机原理验证实验装置 Second forms of gravity machine principle verification experimental device Fig. 59 is an experimental device for the verification of the principle of gravity machines. 1, support, 2, 3, left wheel bearings, bevel gear, and 4 right-handed helical bevel screw, 5, 6, weight hanging, a fixed shaft, 7, 8, hanging weights, pressure wheel bearings, gears, gear wheel 9 pressure cone (spur), 10 round, cylindrical pressure gear tooth (spur), 11, pressure wheel and the pivot wheel pressure contact area, contact pressure, pressure wheel and worm wheel 12, 13, pressure wheel central shaft (the center shaft can not be used to support the weight of the pressure wheel), 14, spring, 15, 16, fulcrum fulcrum wheel bearings, wheel. 17, the fulcrum of wheel gear tooth (cylindrical straight tooth), 18, left-handed helical bevel screw, 19, right angle bevel gear, 20 tension meter (spring, 21 scale), fixed fulcrum wheel support shaft. The size of the important parts affecting the experimental data in the experimental device: the maximum circle diameter of the pressure wheel is 180 millimeters, the minimum diameter is 120 mm, the maximum circle diameter of the worm is 86 mm, and the maximum circle diameter of the worm gear is 86 millimeters. Experiment material: gear is wood, processing method is hand carved, fixed shaft is steel bar A bearing is connected between the fixed shaft and the gear. Machining problems in the experimental equipment: the accuracy of manual machining is low and has some influence on the experimental data. Influence of friction coefficient on energy relationship of experimental device condition The pressure turns round, R, the volute straight =R pot, oblique r1=90 mm, r2=60 mm Work done by worm gear The power that drives the fulcrum wheel to rotate The work needed to increase the consumption of worm Energy output U = Zero point one five WQ=Q 2 pi R2 = (0.904865N2+0.5757W) 2 pi 60=20 PI (5.43 N2+3.45W) (p+F1) 2 pi r1= (0.372 N2-0.395W) 2 pi 90=20 PI (