高级管道工理论知识试卷(外国英文资料).docVIP

高级管道工理论知识试卷(国外英文资料) Knowledge test paper of senior plumber (h-2) part of the answer to the objective question Multiple choice Hydraulic pipe bending machine is used for bending the tube of the outside diameter not exceeding (A) mm A. 44.5 B. 45. 5 C. 46. 5 D. 47. 5 The bending radius should not be less than the diameter of A tube A.3.5 B. 4 C. 4. 5 D. 5 The bending core bar should be placed in the pipe when the diameter of the bending tube is greater than the (C) mm. A.80 B. 70, C. 60 D. 50 After the tube is bent, the thickness of the tube shall not exceed (C). A.5% B. 8 percent C. 15% D. 20% When the temperature change of the pipe is less than (B), the compensation is not considered. A. 300C B. 320 C C. 340C D. 360 c The tensile deviation should not be greater than (A) mm when the waveform stretcher. A. 10, C. 15 D. 20 The inner lining of the waveform extender is welded to the side of the wave wall and the other end can be (C). A. Weld fixed C. Move D. Thread fixed The stretching deviation should not be greater than (B) mm after the square extender is in place. A. Plus or minus 10, C. Plus or minus 15, C. Plus or minus 20 Different flows have A tube diameter that is adapted to the velocity of the economy, which is the (A) of the flow. A. Economic pipe size B. Economic traffic C. Nominal pipe diameter D. nominal flow The maximum velocity is (C) in the network to prevent the damage caused by the water hammer. A.0.5 minus 0.7 m/S B. 1-1. 6m/S. 2. 5-3 m/S D. 3-3.6 m/S For gas, hydrogen, low pressure air, etc., the (B) pressure gauge is generally adopted. A. Spring tube B. Diaphragm type C. Acetylene D. Oxygen type The rotor flowmeter is applied to the line in which the pressure is not greater than (B). A.0.098 Mpa B1. 96 mpa C. 5. 88 mpa D. 6. 3 mpa The u-tube manometer shall be set in the range of the ambient temperature (C). A: 10-500c B. 15 minus 600 C. 10-600c D. 20-600 - c The gauge of gauge should be the maximum mark of the dial (C) when measuring the pipe with f