UAR-250004S3D017-BK(UARD17白胶芯18黑胶芯 - Global Sources.PDFVIP

Generated by Foxit PDF Creator © Foxit Software For evaluation only. PRODUCT SPECIFICATION 1. 一般特性 General Characteristics (Rating Value) 1.1 额定值 : 1.0AMP. (Work Temperature Range) 1.2 工作温度 : -10℃ ~ 70℃ 1.3 存贮温度 : -20℃ ~ 80℃ (Store Temperature Range) 1.4 正常测试条件(未有特殊说明量测在以下条件进行): General test condition (Tests and measurements shall be made under the following standard conditions unless otherwise specified): 正常温度: 5℃~35℃ 相对湿度: 45%~85% RH 气 压: 8,600~10,600帕 Temperature: 5℃~35℃ Relative humidity: 45%~85% Air pressure: 8,600~10,600 pa 2 品外 及尺寸要求 Appearance Dimension Requirement .产 观 2.1产品外形结构紧凑,无配合不良. The structure of product is compact, and assembly of parts has no badness. 2.2 产品塑胶部件无缩水、披锋、欠注、斑点、破损或变形现象. The plastic parts of product have no defects such as very serious shrink, scarcity, fleck, disrepair, transmutation, etc. 2.3 产品引脚和外壳无氧化、脏污、变形、毛刺或电镀不良. Lead feet and shell have no defects such as oxidation, smudge, disrepair, burr, defects on plating. 2.4 连接器插拔顺畅,无明显阻碍. It is unhindered that the plugs work in receptacles, and there is not palpable clag. 2.5 产品结构及尺寸参见产品规格图纸。 Construction and dimensions：Refer to individual product drawing. 3.电气特性 Electronic Characteristics 项 目 测试方法 测试设备 特性要求 No. Item Test Method Equipment Requirements 接触电阻 在低电流（≤100mA）条件下测试. 低电阻测试仪 3.1 Contact Measured at low current (100mA or Low