cad教程 第5章(国外英文资料).docVIP

cad教程 第5章(国外英文资料) This paper is made by Silicon Valley technical contribution Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The fifth chapter edit and modify two dimensional graphics (upper) chapters, edit and modify two-dimensional graphics When drawing architectural patterns using AutoCAD, repetitive editing of architectural shapes takes up a considerable proportion of the editing operations used when drawing architectural shapes. As a result, editing operations take up a great deal of proportion. Therefore, readers should master all kinds of editing commands skillfully and master all kinds of editing commands skillfully so as to improve the drawing speed. The main points in this chapter Initial edit, copy, mirror, offset, array, move, rotate, zoom 5.1 preliminary editing of graphics 5.1.1 object selection and deletion 1. click Select object Direct click objects can select a single object, click multiple objects in turn, select the direct click object, select a single object, and more than one object. 2. use window selection and window selection to select objects If you want to select a group of adjacent objects, you can use window selection or window intersection. If you want to select a group of adjacent objects, you can use window selection or window intersection. Window selection refers to the first click OK choose the left side of the window corner, then move in left to right corner to the right and then move the cursor, the cursor, finally click OK in the right corner, which is from the left to the right corner of the window drag selection window left drag to the right choice, then all completely contained in the selection window object all selected The window is the first to determine the choice of window on the right corner, and then move the cursor to the left side corner, and then move the cursor to the left, click OK the corner, click OK the diagona