cad模型空间和图纸空间的使用(国外英文资料).docVIP

cad模型空间和图纸空间的使用(国外英文资料) People often ask about the use of CAD model space and paper space, the most of which is the drawing problem of different scale drawings! This topic will be discussed from different aspects, such as different editions, different spatial maps and so on! In order to give you a better understanding of the difference and use between them, so as to get twice the result with half the effort in practical application! The content of the topic is as clear as possible, and fully consider the requirements of users at different levels of application! [1] thematic content areas (1) concept of drawing space and model space Zhouhaibo1100 friends provide information: I think since we are talking about this problem, we must first define the concept of the drawing space and the model space. I think the explanation is pretty good. Lets see it in the close-up: You write a few words on a piece of paper, draw some pictures, and then put a sheet of white paper over it - nothing can be seen. Open a small hole on this blank sheet of paper, and put a transparent paper on the little hole youll see a part of the paper below. Pull away the two pieces of paper - you see more and more things, and smaller and smaller. Under the piece of paper called model space, the piece of paper called drawing space, the small hole is called viewport. The distance between two sheets of paper is set with zoom. Note that the small hole is just for you to see. Because the square hole is stuck with a transparent paper, it can not be modified on the paper on it. The transparent paper on the small square hole opened, became a real hole, you can take this pen across the small square hole to change the paper below the thing, this is called active viewport. A small hole can be seen below that piece of paper all the content, this is a small drawing to draw the whole building, as long as the adjustment of two sheets of paper of the distance, then the frame painted on paper, he here is much things,