快速辨别可控硅引足的方法(国外英文资料).docVIP

快速鉴别可控硅引脚的方法(国外英文资料) Fast identification of SCR three pole, that is, the pin method is very simple, according to the principle of P-N junction, as long as the multimeter to measure the resistance between the three poles can be. Between the anode and the cathode of the forward and reverse the resistance in several hundred kilohms, between the anode and the control electrode of the forward and reverse the resistance in several hundred kilohms above (with two P-N nodes, between them and in the opposite direction, so the anode and the control electrode was positive and negative). There is a P-N junction between the control pole and the cathode, so the forward resistance is about a few euro to several hundred euro, and the reverse resistance is larger than the forward resistance. But the gate diode is not ideal, the reverse is not completely in the blocking state, can have a relatively large current through, therefore, sometimes the measured control of reverse resistance is relatively small, and can not explain the bad control characteristics. In addition, in measuring the control of positive and negative resistance, the multimeter should be placed in the R*10 or R*1 block, to prevent the voltage is too high, control reverse breakdown. If the component is positive and negative, the reverse is short circuited, or the anode is in short circuit with the control pole, or the control pole is in reverse short-circuit with the cathode, or the control pole and the cathode are broken open, indicating that the component is damaged. Silicon controlled silicon is divided into two kinds of unidirectional silicon controlled rectifier and bidirectional thyristor, all of which are three electrodes. The unidirectional thyristor has a cathode (K), an anode (A) and a control pole (G). The bidirectional thyristor is equivalent to two single thyristor in reverse connection. Namely, one of the unidirectional silicon anodes is connected with the other cathode, and the leading end is called T2