我的东西(国外英文资料).docVIP

我的东西(国外英文资料) Rock drilling, the bottom of the hole to improve the mud weight and the amount of the hole bottom slurry by general drilling waste slag into supporting buoyancy bond force, the rock drill under the impact of wrapped in mud, to reduce duplication of broken rock. During construction, clay, impact and slag are repeatedly thrown to increase drilling speed. Water head control is generally higher than the ground water level or about 1.5m of the river. The method of timely filling slurry, pumping slurry and cutting slag always keeps the fixed height difference of 1.5m with the water outside the hole to ensure the stability of the water pressure in the hole and the safety of the hole wall. (3) reinforced cage system After completion of the completion of the hole, the inspection hole depth, aperture and vertical inspection meet the requirements, that is, reinforcement cage construction. The steel cage is centrally assembled on the shore, and a special person is responsible for ensuring the geometric size and strapping quality of the steel reinforcement. In order to ensure that the carriage is not deformed during the carriage, the steel cage is strengthened with cross support. The steel cage is lifted into the hole by a crane, and the length of the weld is welded at the orifice and keeps the upper and lower sections on an axis. When the steel cage falls to the designed elevation, the hanger is firmly connected with the protecting cylinder or platform to prevent the cage from falling out or floating. The reinforcement cage should be installed carefully to ensure that the thickness of the concrete wall of the pile wall and the elevation of the reinforcing cage meet the design requirements. After the steel cage is installed, two cleaning holes are carried out. After cleaning, the slurry performance indicator shall be reported to the site supervision engineer for acceptance. 3) the construction plan of automobile crane installation beam plate (1) preparation; The si