电子防滑器资料(国外英文资料).docVIP

电子防滑器资料(国外英文资料) This article is contributed by Gd_nnny DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Electronic anti-skid device information An electronic antiskid device composed of electronic antiskid device for antiskid fast trains, electronic bicycle anti-skid system mainly consists of the following parts: 1, 2, 3, 4, 1 computers; speed sensor 4; exhaust valve 4; pressure relay 1; Two, the working power supply power line No. 28, line 29, line 28 - 129 line requirements for power supply ripple + with a multimeter measuring the exchange of files should be less than 5V A. working voltage: 48V DC voltage, the starting voltage: 42V, voltage: 37V, shut down maximum working voltage: 70V B. wire: analog, digital, a 48 volt negative line; three, the host host layout of a total of 8 circuit boards, all plug, respectively from left to right: 1, S1 card: connect the speed sensor, the main function for receiving a speed signal, and for Zoom and reshape; 2, S2 card: the main function is to digitize the S1 card shaping speed signal (counting function) a digital signal that an output host can process; 3, CP card: the host can complete all functions of the command center, there are 16 CPU80198, ROM32K, RAM2K, EPROM2K; 4, V1 card: A. will 48V to 4 B. when the power shaft speed greater than 2KM/ seconds when the valve is closed; 5, 6, 7, V2 card: complete the electronic exhaust valve, safety electromagnet control circuit; PW card: power module, complete the 48V transformation of 5V filter, 48V change: 12V PC card power starting circuit, delay shutdown, power cut off the power supply, Filter 8 and PR card: perform polarity protection, filter, voltage limiting protection function Four, speed sensor has three leads, namely: +, - -, B, which +, - for the power line, B for shielding line, shielding line to butt well, can not be exposed. Determine the speed sensor is available mult