短肢剪力墙的配箍绿(国外英文资料).docVIP

短肢剪力墙的配箍绿(国外英文资料) The reinforcement problem of short leg shear wall structure in non seismic area is discussed Non seismic zone 15 storey short shear wall structure reinforcement, all the longitudinal reinforcement of short pier shear wall section rate according to the number and structure design for? How to configure the edge members of stirrup stirrup ratio, to meet the requirements? 1. non seismic area 15 layer short leg shear wall structure, all longitudinal reinforcement ratio is best to take 1%, 2. the volume ratio of stirrups of the edge component satisfies the minimum volume, the reinforcement ratio is good, that is to say, the stirrup characteristic value is v 0.1 Hoop green of short limb shear wall According to the diagram given in the current specification, the use of stirrups is only specified in the shadow areas, rather than by drawing tendons, The reinforcement shall be included in the stirrup volume and stirrup ratio. However, many designers consider pulling the tendons into the volume ratio, The reason is similar composite stirrups, and the columns of the columns are not aimed at shear resistance. To do so, in the steel bar There will be a certain amount of savings. Wall to column stirrups in general high-rise buildings are more common with D12@100, of course Well, after the new specification, it can basically meet the requirements of volume stirrup ratio, so the reinforcing bars in the constraint component are required Configuration can also be configured. But in some cases, for example, if a steel bar is to be used as a stirrup, it may be simply sealed The closed stirrups are difficult to satisfy. Whether horizontal reinforcement can be included in stirrup volume and stirrup ratio is debated continuously. I dont think thats relevant to the specification Technical explanations are directly related, or further, the norm should be responsible for this. Because the specification itself is not clear Make sure that the shear wall sets up the wall column