标题(Heading)1(Alt 1).pdfVIP

Driver Installation for DG40XXHC Series Boards DG40XXHC Series DVR board Driver Installation Manual Installation steps (Normally) Before you run DVR program, you must install correct drivers for DVR boards at first. First, Double-click the driver installation program “DriverInstall.exe”, a dialog will display. Figure 1:Double-Click “DriverInstall.exe” Click “Install” to install drivers. When it informs that all drivers have been installed successfully, you can click “OK” button to exit the program. 1 Driver Installation for DG40XXHC Series Boards Figure 2: Finish installation After the Drivers has been installed. When we open the Device Manager, we will see the following window. “H.264 DVR CARD” sign Driver has been installed successfully. Each board DSP chipset will own one driver here. Figure 3: Check drivers had been installed 2 Driver Installation for DG40XXHC Series Boards Attention: If our PC has installed DS series board (Hikvision series board) before you install DG40XXHC series board, maybe windows will install its drivers as DS series board. So you must reinstall DG40XXHC series board as following steps: First, Single-Right-Click “My computer” and choose “Properties”. In the window click “Hardware”, and then Single-Left-Click “Device Manager”. We will find the “DS 40xxHC Series”, which signs our board has installed as DS series board. Figure 4 Check drivers Then you should Single-Right-Click “DS 40xxHC Series” and choose “Properties” 3 Driver Installation for DG4