森吉米尔轧机轧件板形与边部减薄预报软件开发.pdfVIP

标准分享网 提供免费下载 森吉米尔轧机轧件板形与边部减薄预报软件开发* 喻海良, 刘相华，陈礼清 轧制技术及连轧自动化国家重点实验室(东北大学), 沈阳, 110004） （ 摘 要：利用接触元双坐标法（CEM ）建立了双 AS-U-Roll 系统森吉米尔轧机轧制过程中轧件及辊系变形 行为的 CEM 函数矩阵，并开发了 SM4SM （Setup Models for Sendzimir Mill）软件。该软件能够很好 的预报各种轧制条件下轧件截面形状、轧件边部减薄、轧制力、轧辊挠曲等功能。本文应用 SM4SM，分 析了第一中间辊锥角、锥度长度和窜辊长度对轧件截面形状和轧件边部减薄控制的影响。研究结果对冷轧 过程控制轧件板形和边部减薄具有重要的参考价值。 关键词：板形；边部减薄；数值模拟；森吉米尔轧机 Development of a Software for Prediction of Strip Profile and Strip edge drop of a Sendzimir Mill YU Hai-liang, LIU Xiang-hua, CHEN Li-qing (The State Key Laboratory of Rolling and Automation(Northeastern University), Shenyang 110004) Abstract: A CEM matrix for analysis of the deformation of the rolls and the strip in cold rolling of a Sendzimir mill with double AS-U-Roll systems has been established and a software SM4SM(Setup Models for Sendzimir Mill) has been developed by the Contact Element Method with Two Relative Coordinates (CEM). The strip profile, the strip edge drop, the rolling force, the roll deflection, etc. can be predicted under certain rolling condition. In this paper, the influence of the taper length, the taper slope and the shift of the first intermediate roll on the strip profile and the strip edge drop are analyzed with the software of SM4SM. The calculated results are of good significance for improvement the strip quality in cold rolling process. Key words: strip profile; strip edge drop; numerical simulation; Sendzimir mill 1 前言 森吉米尔轧机由于工作辊直径小、刚度大，广泛应用于冷轧不锈钢带、硅钢带、高精度及极薄 钢带和有色金属高精度带材的轧制。自从 20 世纪 30 年代以来，森吉米尔轧机使用量约为 400 台。 [1] 为了提高轧件质量、产量，研究者们对其进行了一系列的研究。Schneider 等 研究了 20 辊轧机冷轧 [2]