全国电子设计大赛试题(国外英语).docVIP

全国电子设计大赛试题(国外英语资料) The national college electronic design competition in 2009 Problem A -- the photovoltaic system Problem B -- voice guidance system Problem C - broadband dc amplifier Problem D -- wireless environmental monitoring simulator E - power collection chargers F - the digital amplitude frequency equalizing power amplifier G -- low-frequency power amplifier H problem - LED dot matrix writing display Problem I - analog street lighting control system 2007 national college students electronic design competition Audio signal analyzer (A) 【 】 undergraduate group A, task, Design, make an analysis audio frequency component, and can measure the instrument of the distortion degree of sine signal. Second, the required 1. Basic requirements (1) the input impedance: 50 Ω (2) input signal voltage range (peak - peak) : 100mV ~ 5V (3) input signals contain a range of frequencies: 200Hz ~ 10kHz (4) frequency resolution: 100Hz (accurate measurement of the power value of the frequency component of the frequency difference not less than 100Hz). (5) the total power of the input signal and the frequency and power of each frequency component are detected, and the power of each frequency component detected is not less than 95% of the total power value. The absolute value of the relative error of the relative error of each frequency component power measurement is less than 10%, and the absolute value of the relative error of the total power measurement is less than 5%. (6) analysis time: 5 seconds. Data should be analyzed in 5 seconds refresh cycle, each frequency component of the signal should be according to the power, according to the size, in turn, storage and playback and real-time display signal and at least the first two frequency component of the total power frequency value and power, and display the data set pause button. 2. Play a part (1) increase the dynamic range of input signals and improve sensitivity. (2) input signals contain a range of frequencies: 20Hz ~ 10kHz