典型轴类零件的加工工艺(国外英文).docVIP

典型轴类零件的加工工艺(国外英文资料) This subject mainly studies the machining process, processing techniques, points of attention and improvement methods of shaft parts. By summing up the processing of non-standard parts and the processing examples of typical semi-finished products, shaft parts are explained. Now many manufacturing factories in order to improve the final product performance or reduce the cost of some machines, looking for machinery factory custom, often because of making equipment, technology or process is not very good, the processed parts can not meet the use requirements, so the need for a summary, improved processing technology, so as to improve the product. After summarizing the problems in production, the paper was written. Shaft parts are one of the typical parts often encountered in machines. It is mainly used to support gears, pulleys, cams and connecting rods in machinery to transmit torque. According to the structure form, the shaft can be divided into ladder shaft, taper mandrel, optical axis, hollow shaft, crankshaft, cam shaft, eccentric shaft, all kinds of lead screw and so on. Fig. types of shafts A) optical axis B) hollow shaft c) half shaft d) ladder shaft E) spline shaft f) cross axle g) eccentric shaft H) crankshaft I) camshaft The function and structural features of 1 axle parts Shaft parts are one of the typical parts often encountered in machines. It is mainly used to support gears, pulleys, cams and connecting rods in machinery to transmit torque. According to the structure form, the shaft can be divided into ladder shaft, taper mandrel, optical axis, hollow shaft, crankshaft, cam shaft, eccentric shaft, all kinds of lead screw and so on. It is mainly used to support transmission parts, transfer torque and bear load. Shaft parts are rotating parts, the length is greater than the diameter, generally by the concentric shaft of the cylindrical surface, cone surface, inner hole and thread and the corresponding end face. According to the shape of