放电管2(国外英语).docVIP

放电管2(国外英语资料) n The circuit board of the circuit board and the outside contact is possible to add, for example: the working power input circuit, the analog quantity, the signal quantity input and output circuit. This is the equivalent of integrating a lightning guard onto the board. Major specifications/special functions: Product synopsis: The gas discharge tube is a voltage leading switch device which is in parallel between the line of the protected device and the line or line of the device (as shown below). When foreign surge voltage of the actuating voltage, discharge tube with high resistance (more than 1000 m Ω) insulation resistance state, and once the surge voltage reaches its action voltage, discharge tube internal electric breakdown occur immediately discharge gap, the discharge tube is equivalent to a good conductor, the surge voltage in the 50 ns time was short circuit quickly to near zero voltage and surge current are quickly import, thus to protect equipment. When the surge voltage vanishes, the discharge tube immediately extinguishes and is restored to the high resistance state, waiting for the next action. First, the principle of protection Under normal circumstances, discharge tube because of its unique high impedance (1000 m Ω or higher) and the low capacitance (pf) 10 or less features, in it as a protection device access lines, the normal work of the on line almost does not have any adverse effect. When harmful transient over voltage sensor, discharge tube was first breakdown discharge, the impedance drops rapidly, almost a short circuit condition, at this point, the discharge tube will be harmful to the current through the ground leakage to the earth, and at the same time limit the voltage on the arc of discharge tube (about 20 v or so), to eliminate harmful transient overvoltage and overcurrent, thus protect the lines and components. When overvoltage disappear, discharge tube and rapid return to a high impedance state, continue to work normally. S