2010年挖掘机考试最新模拟试题(外国英语资料).docVIP

2010年挖掘机考试最新模拟试题 One judgment 1 V-belt drive capability, A, with minimum, O, with maximum. 2 tension pulley with triangle belt, its installation position should be on the inside side of the V-belt loose edge as close as possible to the big pulley side. 3 key kinetic energy to ensure accurate average transmission ratio, transmission power is relatively large. 4 the driving gear and the driven gear have equal teeth spacing, so that the correct meshing can be ensured. An intermediate gear in the 5 gear train can be a driven wheel of the front stage and a driving wheel at the rear stage. 6, when the volume of work is the same as the speed, the two stroke gasoline engine is larger than the four stroke gasoline engine. The 7 side valve type air distribution mechanism is favorable for the engine to inflate and exhaust the exhaust gas, so the power and the economy of the engine are better. 8 engine in different conditions for combustible mixture concentration requirements are different. 9 when the rope is connected by a rope clamp, the rope clamp shall be placed on the side of the long rope of the wire rope. 10 when the object is hoisted, the center of gravity is not found, and the steel rope will not topple when it is firmly secured. 11 when the rope is connected with a rope clip, the length of the last rope is not less than 140 mm. 12 the diameter of the wire rope should be measured with a vernier caliper and the minimum value should be measured. 13 excavators shall not excavate rocks or frozen soil beyond grade five without blasting. 14, crawler excavators should be slow downhill driving, not on the ramp speed change. 15 piston is a kind of crank connecting rod mechanism. It is not only a combustion chamber, but also a high temperature and pressure. 16, in the transmission power under certain circumstances, the triangle belt speed is too large or too small, the same slippery phenomenon. 17 used in the transmission or spiral transmission of trapezoidal thread, the proces