DT9205A 万用表详细使用说明(外国英语资料).docVIP

DT9205A 万用表详细使用说明 DT9205A digital multimeter usage details (1) put the ON/OFF switch in the ON position and check the 9V battery. If the battery voltage is not enough, it will be displayed on the monitor, then you need to replace the battery. If the monitor does not appear, follow these steps. (2) testing the symbols next to the pen Jack to indicate that the input voltage or current should not exceed the indicated value, in order to protect the inner line from damage. (3) before testing. The function switch should be in the range you need. 1-1 DC voltage measurement 1. the black pen is inserted into the COM socket, the red pen is inserted into the V/ socket. 2. the function switch in the DC voltage range and the V- file, the test pen is connected to the tested power supply (measuring open circuit voltage) or load (load voltage drop), the polarity of the red pen connected end will be simultaneously displayed on the display. Be careful： 1. if you dont know the range of voltage to be tested, switch the function switch to the maximum range and gradually decrease 2. if the display only shows 1, indicating the range, the function switch should be placed in a higher range 3. means not to measure the voltage higher than 1000V, indicating that higher voltage values are possible, but there is a risk of damage to the internal wiring 4., when measuring high voltage, we should pay special attention to avoid electric shock 1-2 AC voltage measurement 1. the black pen is inserted into the COM socket, the red pen is inserted into the V/ socket. 2. put the function switch in the AC voltage V~ range, and connect the test pen to the power or load to be tested. The test connection diagram is the same as before. There is no polarity indication when measuring AC voltage Be careful: 1. see DC voltage, note 1.2.4. 2. means not to enter a voltage higher than 700Vrms, indicating that a higher voltage value is possible, but there is a risk of damage to the internal wiring 1-3 DC current mea