《砌体工程施工质量验收规范》 简介(外国英语资料).docVIP

《砌体工程施工质量验收规范》 简介 Brief introduction to code for acceptance of construction quality of masonry work GB50203-2002 3.0.1 the materials used for masonry work shall be certified by the product and the product performance test report. The main performance of bulk cement, steel and other additives are due to material entering the re inspection report. Prohibited the use of state obsolete materials. 3.0.4 retaining temporary construction hole on the wall, its side from the junction wall should not be less than 500mm, the net width of the hole should not exceed 1m. The openings, ducts and trenches required by the 3.0.7 shall be properly laid aside or buried in masonry, and shall not be drilled into the wall and horizontally dug on the wall without design consent. The upper part of the width is more than 300mm, should set the lintel. 3.0.9 shelving of precast beams and slabs shall be made of flat top and shall be lined with grout. When the design does not require concrete, 1:2.5 cement mortar should be used. 3.0.10 masonry construction quality control level should be divided into three levels, and should comply with the provisions of table 3.0.10. 3.0.14 test of masonry engineering group acceptance, the main project should meet all the provisions of this regulation; the general project should be 80% and over sampling at compliance with this specification, or deviation in the allowable deviation range. 4.0.1 cement shall be checked in batches for strength and stability before they come into use. test The batch shall be the same manufacturer and the same number as the batch. When there is any doubt about the quality of the cement in use or if the cement has been in production for more than three months (the rapid hardening of Portland cement for more than one month), the test shall be reviewed and used as a result. Different kinds of cement shall not be used in combination. In the construction of 4.0.7, when the cement mortar is used instead of cement mixture mortar, the str