光驱常见故障分析(外国英语资料).docVIP

光驱常见故障分析 Common trouble analysis of CD driver -------------------------------------------------------------------------------- At 21:37 on October 15, 2005 After a failure, the system cannot find the drive into the CD-ROM fault phenomenon: to detect CD-ROM system self, but found no CD-ROM drive under the Windows operating system. Fault analysis: there are several possibilities for this situation: in the safe mode into the operating system, the machine infected with the virus, Windows operating system comes with CD-ROM driver failure. Solution: since the operating system in safe mode does not load any drivers, it is normal to not find drive. Here we only say two, if you exclude the virus causes also can not find CD-ROM letter words, can use the following two methods: first, access control panel, select add new hardware, then follow the prompts to step down, when the system check, usually can be found CD-ROM; two into the control panel, select device manager, which will be the hard disk controller deleted items, and then restart your computer. Because of CD-ROM and hard disk using the same controller, so as to remove it and will be identified automatically restart after the general will be able to retrieve the CD-ROM letter; three, if not more than, can drive CD-ROM in DOS mode, such as loading a universal CD-ROM driver IDE.SYS; one last trick is to ban 32 a pattern in the performance options on the Win98, but this is at the expense of the performance of the system to solve the problem. Fault two, after installing CD-ROM, affect the speed of the hard disk Fault phenomenon: a compatible machine after the installation of CD-ROM, and found that when the CD-ROM disk read, the hard disk running speed slow down, and even if the CD-ROM does not put the disk, the hard disk running procedures, there will be a standstill. Fault analysis: initially concluded that the hard disk and drive are connected with the same data line, and shared IDE1 interface failure. Because the curren