两级圆柱齿轮减速器的的设计及有限元分析.doc

题 目 两级圆柱齿轮减速器的设计及有限元分析 学生姓名 e 学号 ee 所在学院 机械工程学院 专业班级 ee 指导教师 ee __ 完成地点 校内 2009 年 6 月 17 日  两级圆柱齿轮减速器的设计及有限元分析 (ee) 指导教师：ee [摘要]本设计是一二级圆柱齿轮减速器，完成齿轮设计、轴设计、齿轮及轴强度校核等计算 [关键字]减速器Pro/E，三维造型  The design and finite element analysis of two cylindrical gear reduce ee (ee) Tutor: ee Abstract: The design is an expansion of two cylindrical gear reducer, The main purpose is to improve the design efficiency of reducer and gear mesh in two gear nonlinear stress analysis. This paper mainly use the Pro/E software for 3D software and finite element analysis software ANSYS. First of all, by calculating the complete gear design, shaft design, gear and axle strength check calculation; Then, three-dimensional modeling design for the reducer using Pro/E software, and analyzed the model assembly and motion simulation, the design results reflected more intuitive; Finally, one of the gear parametric modeling using ANSYS software, The use of APDL language automatic generation of involutes’ gear in ANSYS software, To use graphical interface mode of operation, through the mirror, rotate command, generates two meshing gears, And it is a nonlinear stress analysis, The size of the two gear contact stress distribution reprogram. Through the analysis of 3D modeling and Simulation of the reducer using Pro/E software, We can actually exercise process through the simulation of virtual reducer, In order to improve the accuracy of design and shorten the design cycle, Through the use of ANSYS software analysis of the stress of gear mesh, We can know, Using traditional methods of design of gear, The gear reliability amplification, In the process of design, we can reduce the gear size, which saves raw materials, reduces the production cost. Key words: reducer,