美国福斯LGENBR3000系列说明书.pdf

Logix 3000 Series Digital Positioner Experience In Motion The Logix 3400IQ offers local setup and calibration in seconds... easy as 1, , 3 With the 3400IQ, function blocks are no longer required to set up, configure and perform a simple stroke calibration. The 3400IQ can be set up with 9-32 VDC supply and 45 psi (min.) air supply on any valve/actuator platform. When the 3400IQ is in OOS (Out Of Service mode), the local interface shown to the right is accessible and setup can be carried out through the following steps: 1. Make sure the mechanical linkage, air tubing and actuator mounting are correct. 2. Set the configuration switches to the desired operation of the valve/actuator. 3. Set the quick calibration switch to Jog or Auto. In Jog, the 100% position can be manually adjusted using the yellow up and down buttons after Re-Cal is pressed. In Auto, the positioner finds the 100% position and calibration is complete. LED blink codes will guide the user through the process. Four green blinks (GGGG) or (GGGY) at the end of the sequence confirm that the calibration was successful. Calibration, configuration and tuning parameters from the local interface will be automatically updated in the 4. If needed, the GAIN switch located to the right of the Transducer Block on the Logix 3400IQ. Local setup and jog buttons will speed up o